Rear Wings Variations

Our range of lightweight rear wings includes various designs and widths.

As with all of our parts, these rear wings are extremely robust against stone chips, as well as against stones that stick to the tyre and are then flung against the wings from below.

We offer these wings in either a fibreglass or carbon fibre weave which is mixed with a special epoxy resin system to achieve the necessary elasticity. Thanks to this approach, there aren't any so-called "star cracks" to be found in the finish of our products.

The overall design and shape of the right-hand side is always the same. However,  the left-hand side rear wings can vary depending on whether or not there is an exhaust cut-out. This LHS cut-out is available on all Kent (Crossflow), Rover K-Series and Opel Vauxhall equipped models.

This cut-out is not present on all recent Caterham models, as the exhaust is on the right-hand side. Because of this, a special cut-out is not necessary on all later models.

Please make sure to request for a LHS exhaust cut-out when ordering rear wings in the standard width, as we will otherwise supply these without a cut-out by default.

Special designs in +25 and + 55mm are available but only with a LHS exhaust cut-out, with all RHS wings in these sizes only being available without  a cutout.