Sequential Shift Light

Hardware

CARTEK
SEQUENTIAL SHIFT LIGHT
177,31 € incl. 19 % VAT
149,00 € excl. VAT


Diese Sicherheitsfrage überprüft, ob Sie ein menschlicher Besucher sind und verhindert automatisches Spamming.

8 + 1 =
Solve this simple math problem and enter the result. E.g. for 1+3, enter 4.

The Sequential Shift Light from CARTEK helps indicate the precise upshift time to assist drivers in gaining maximum performance from their engine.

This fully integrated device is designed to be mounted onto the dashboard and works with most ignition systems and tacho signals.

The unit is quickly and easily programmable, requiring just 3 electrical connections.

  • Fully integrated unit
  • Fully programmable
  • Easy to install and setup
  • Compatible with most ignition and ECU rpm signals.
  • Dash mountable unit
  • Waterproof

HOW IT WORKS
The CARTEK Shift Light takes in an RPM Signal, 12V Power, and ground. An extra white wire is used to put the unit into setup mode. This is achieved by touching the setup wire to chassis/earth and then starting the engine. Two outer green LED’s will begin to flash, which indicates that you have activated the setup mode.

When first entering this mode, you must proceed by storing the lower RPM of the sequence. To do this raise the revs to your starting point and then immediately reduce the revs. The Shift Lights will have stored the RPM that you want to start at.

Then touch the setup wire to chassis earth to enter the setup mode a second time. This time, you must proceed by raising your revs to the highest point you want the Shift Lights to finish at. Immediately reduce the revs again for the shift light setting to be stored at the highest RPM.

Touch the setup wire to chassis earth to finish the setup mode. It will calculate all intermediate LED levels of the sequence and will be ready to use.